<th id="p7h1p"><noframes id="p7h1p">
<legend id="p7h1p"><address id="p7h1p"></address></legend>

<listing id="p7h1p"></listing>

  • <code id="p7h1p"></code>
  • <legend id="p7h1p"><em id="p7h1p"><track id="p7h1p"></track></em></legend>
  • <td id="p7h1p"></td>
  • <span id="p7h1p"></span>

     
    其他欄目
    學術報告
    Assoc. Prof. Yi Yang 學術報告會
    作者:發布時間:2020-01-07

    題目:Quantifying Uncertainty in Kinetic Simulation of Engine Autoignition

    時間:2020年1月7日 10:00-11:30

    地點:機械與動力工程學院 F310會議室

    報告人:Assoc. Prof. Yi Yang (University of Melbourne)

    邀請人:韓東 特別研究員(內燃機研究所)

     

    Biography

    Dr Yi Yang is an Associate Professor of Mechanical Engineering at the University of Melbourne. His research includes combustion chemistry, low emission fuels, advanced combustion engines, and fuel/engine interactions. He received his PhD from the Pennsylvania State University in 2008 and conducted postdoctoral research at Sandia National Laboratories before joining the University of Melbourne in 2012. He is a member of the Combustion Institute and the Society of Automotive Engineers. He is an Associate Editor of the SAE International Journal of Engines and currently serves on the board of the Combustion Institute – Australia and New Zealand as the Section Secretary.

     

    Abstract

    Combustion chemistry models have been developed with inherent uncertainties in them. Whether a model developed using fundamental combustion experiments can reproduce practical combustion processes within typical levels of measurement uncertainty is an open question. In this talk, we quantify the uncertainty of engine autoignition simulation using the deterministic, bound-to-bound data collaboration approach. A case study is reported for autoignition of n-pentane in a standard octane rating experiment using a two-zone combustion model coupled with a detailed chemistry model. The results show that the prediction uncertainty of a comprehensively tested n-pentane model is substantially higher than the measurement uncertainty of engine experiments. In-cylinder thermochemical conditions, such as the temperature at the intake valve closure and the heat transfer coefficient, are found to be less important than reaction rate coefficients in determining the model uncertainty. The large prediction uncertainty can be reduced by constraining the model with fundamental experiments including ignition delays and species concentrations, and more significantly, with autoignition timings from well-calibrated engine experiments. Finally, the model prediction uncertainties are evaluated in terms of octane number measurement errors using two sets of CFR engine experiments, from which the uncertainty of the most constrained model is found to be comparable to the tolerance allowed for standard octane number tests.

     

     

     

    Copyright ? 2016 上海交通大學機械與動力工程學院 版權所有
    分享到

    Email:sjtume@sjtu.edu.cn
    地址:上海市東川路800號上海交通大學閔行校區機械與動力工程學院
    郵編:200240

    中国足球彩票_足彩胜负14场